Reset Wallet Code :
*#7370925538#
This will factory reset the wallet, and you will have to give it another code. Please type the code in while on the stand by screen. Note that you will lose all previously saved data in your wallet.
Restore Factory Settings :
*#7780#
Your default lock code is 12345
Soft Format :
*#7370#
Your default lock code is 12345
Also make sure your battery is atleast 75% full.
Hard Format :
Hard Format can be done if your phone is facing any of the problems mentioned below :
1. Blank screen. Phone unable to reboot.
2. Phone only able to boot-up to "Nokia" word screen.
3. Installed some program but not able to uninstall it after that.
4. Error messages such as "Child Installer" keeps popping-up.
Make sure cell battery is atleast 75% charged. If its not then you are putting your cell at risk. If its atleast 75% charged then do the following:
1. Switch off the phone.
2. Hold down the following three buttons: Green (call answer) button, * button, and '3' button.
3. While holding these buttons, press the power button and switch on the phone.
4. When the message 'Formatting' appears on the screen, release all of the buttons.
The procedure takes some minutes (approx. 3-4) so dont panic.
Note that you shouldn't switch the phone off or remove the battery when performing either of these operations.
To check the IMEI (International Mobile Equipment Identity) :
*#06#
Information you get from the IMEI :
XXXXXX XX XXXXXX X
TAC FAC SNR SP
TAC = Type approval code
FAC = Final assembly code
SNR = Serial number
SP = Spare
To check the phone Software Version (Firmware) :
*#0000#
Information you get from the it : (eg)
V 5.0604.0
23-01-06
RM-51
1ST Line = Software Version (Firmware)
2ND Line = The date of the software release
3RD Line = Phone type
Clock Stopping :
*#746025625#
To check if the Sim-Clock can be Stopped. This option is dependant on your service provider network. (Sim-clock-stop is a kind of standby mode which will save battery time).
The code to read out the sim-lock status of your phone is :
#PW+(MASTERCODE)+(Y)#
MASTERCODE = 1234567890
Y = NUMBER 1 TO 4
The master code is a secret code. The code has 10 digits. It must be computed with a program e.g. SmartDCT4Calc and/or DCT 4 code Calculator from IMEI etc.
"Y" Shows the status of the network-lock. Here you can enter a number from "1" to "4". The "4" is for the sim-card lock.
SIM-LOCK CHECKS :
#PW+1234567890+1# = GIVES PROVIDER-LOCK STATUS
#PW+1234567890+2# = GIVES NETWORK-LOCK STATUS
#PW+1234567890+3# = GIVES COUNTRY-LOCK STATUS
#PW+1234567890+4# = GIVES SIM-CARD-LOCK STATUS
No comments:
Post a Comment